Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Jackson Heights Homeowners
Leaky ducts waste the money you spend heating and cooling, and in Jackson Heights they can pull dust, exhaust, and basement odors straight into the rooms you live in. Whether it’s a split seam behind a co-op wall, a crushed flex run in a prewar two-family, or gaps around a rooftop unit in a brick apartment building, we find the leak and fix it rather than clean around it. Our technicians have up to 9 years of experience, and every job ends with documented results you can see. Call (844) 443-4566. We answer 24/7. Fast dispatch from 7am to 7pm.
What Our Duct Repair & Sealing Service Includes
Duct repair and sealing is the part of indoor air work most cleaning-only companies skip. We bring Rotobrush and Nikro equipment to clean and inspect the system, then we close the leaks and repair the damaged sections that were letting air, dust, and heat escape in the first place. From cleaning to sealing, one call covers the whole chain.
Duct Sealing
Sealing means closing the joints, seams, and small openings that let conditioned air leak out before it reaches your rooms. You need it when certain rooms never feel the temperature the thermostat says, or when heating and cooling bills creep up without a clear reason. We locate the leaks with airflow and inspection tools, then seal them with the right product for the duct material, not a one-size tape job.

Flex Duct Repair
Flexible duct is common in the branch runs that feed individual rooms, and it tears, kinks, or separates at the connections over time. When a flex run is crushed or disconnected, that room gets almost no airflow and the system works harder to compensate. We reconnect, straighten, or replace damaged flex sections so each branch delivers the air it’s supposed to.

Metal Duct Repair
Galvanized metal trunk lines handle the bulk air in most Jackson Heights buildings, and the seams and joints are frequent leak points. You need metal duct repair when you hear rattling, see visible separation, or notice cold spots near a trunk run. We re-seal seams, reattach loose sections, and repair the metal itself so the main spine of the system stays airtight.

Duct Insulation
Insulation wraps the ducts to keep air at the temperature your system produced, and in unheated spaces like attics or basements that wrap breaks down or falls away. Missing or damaged insulation means you pay to heat air that cools off before it reaches you, and it invites condensation on cold surfaces. We replace failed insulation so the air arrives intact and the ducts don’t sweat.
Mastic Sealant
Mastic is a brush-on sealant made for duct work, and it holds where ordinary tape fails under heat and time. It’s the right choice for permanently sealing joints and seams on metal duct, especially at the connections contractors often leave loose. We apply mastic where it belongs so the seal lasts through heating and cooling cycles instead of peeling off in a season.
Air Leak Repair
Air leaks are the invisible cost in most duct systems: gaps at the plenum, unsealed takeoffs, and openings where a duct was cut and never closed. They waste conditioned air, pull in dust and moisture, and make your equipment run longer than it should. We trace the leaks with airflow testing, then repair each one and confirm the difference. From cleaning to sealing, this is the step that makes the rest of the work hold.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
Duct repair sits on top of the equipment already in the building, and knowing how that equipment behaves matters. We work with Honeywell controls and know how duct pressure and leak rates affect what the system is telling the thermostat. We also handle Aprilaire filtration and humidity components, which interact directly with sealed, correctly sized ducts. When leaks are fixed and airflow is right, a filtration or humidity setup finally works the way it was designed to.
For the sanitation and air-quality side, we use Abatement Technologies and Guardsman products built for environmental and industrial-grade work rather than off-the-shelf retail sprays. That matters when a repair opens up a duct and releases years of settled debris. Whether you have Honeywell, Aprilaire, or any other make, we can help you get the ductwork back to where it belongs.
Signs You Need Duct Repair & Sealing Right Now
- Rooms that never reach the set temperature. If the bedroom stays cold while the living room sweats, a branch duct is probably leaking or disconnected. That gap sends air somewhere other than the room it was meant for.
- Dust that returns soon after cleaning. Fresh dust settling on furniture days after a cleaning often means the ducts are drawing it in through leaks. Sealing the openings stops the cycle at the source.
- Rising energy bills with no other explanation. Leaky ducts push your equipment to run longer to hit the thermostat. The waste shows up on the monthly bill before it shows up anywhere else.
- Rattling, whistling, or humming from the ducts. Noise at a joint or takeoff usually means loose metal or a gap where air escapes under pressure. It’s an easy sign to catch early, before the leak grows.
- Visible gaps, tape peeling off, or crushed flex runs. Old cloth tape dries out and metal seams pull apart, and flex can be crushed in a tight ceiling. What you can see at an accessible joint is often a sign of more hidden behind the walls.
Our Duct Repair & Sealing Process – Step by Step
- 1
Inspection and airflow testing. We start by mapping the system and testing airflow, so we know where the pressure drops and where leaks are likely. Then we look inside accessible runs with inspection tools to confirm what the readings suggest.
- 2
Cleaning before repair. We clean the ducts with Rotobrush and Nikro equipment before sealing anything, because sealing over debris traps it in place. A clean system also makes it easier to see the actual damage.
- 3
Locating and documenting each leak. We mark the leaks we find and photograph the before-condition, so you see the same problems we do. This is the point where a quote stops being a guess.
- 4
Repair and seal. We repair damaged flex and metal, replace failed insulation, and seal joints and seams with mastic and the right product for each surface. Every fix matches the duct material so it holds through seasonal cycling.
- 5
Verification and after-photos. We re-test airflow to confirm the repairs worked, then hand over before-and-after photos of your own ducts. If the numbers don’t improve, the job isn’t done.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Jackson Heights?
Duct repair and sealing in Jackson Heights is priced per job from a written estimate, not by the vent or by the hour. A typical small leak repair and sealing job runs in the lower hundreds, while replacing crushed flex runs across several rooms or re-sealing a long metal trunk line runs higher, often into the low four figures depending on how much duct is involved. Insulation replacement and mastic sealing are usually quoted as part of the same estimate, so the number you see covers the whole scope rather than a series of add-ons.
What moves the price: how many runs need work, whether the ducts are accessible or buried behind finished walls, the duct material, and whether insulation also needs replacing. The honest way to avoid overpaying is to skip the coupon price that grows once the technician is on site, and ask for a flat price per system agreed before work starts, with before-and-after photos. Our free estimate includes the inspection, a written scope, and a clear number. Call (844) 443-4566 to schedule yours.
Duct Repair & Sealing Near Jackson Heights – Our Service Area
We serve Jackson Heights and the neighborhoods around it, including East Elmhurst, Elmhurst, Corona, Woodside, Rego Park, Maspeth, and Sunnyside, and we also reach Bellerose Terrace and Great Neck Gardens. The brick apartment buildings and prewar homes across these areas have duct layouts we know well, and we schedule around your building’s access rules. If you’re nearby and want the same work, see our duct repair & sealing page for Bellerose Terrace, or the one for duct repair & sealing in Great Neck Gardens.
Serving Jackson Heights, NY – Our Local Coverage Area
We serve Jackson Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Jackson Heights
Duct repair and sealing is the work of closing leaks and fixing damaged sections in your ductwork so conditioned air reaches the rooms it’s meant for. It includes reconnecting or replacing crushed flex, re-sealing metal seams and joints with mastic, replacing failed insulation, and repairing air leaks at the plenum and takeoffs. It’s different from cleaning, which removes debris but leaves gaps in place. We handle both, and we pair the repair with cleaning so nothing gets sealed over. Call (844) 443-4566 to talk through what your system needs.
Most duct repair and sealing jobs in Jackson Heights take a day, though larger buildings or jobs with ducts buried behind finished walls can run longer. A small leak repair on an accessible run is often a few hours. We give you a time window in the free estimate once we’ve seen the system. Call (844) 443-4566 to book an inspection.
Duct repair and sealing in Jackson Heights is priced per job from a written estimate, with small leak repairs in the lower hundreds and larger multi-run jobs into the low four figures. The final price depends on how many runs need work, accessibility, and whether insulation also needs replacing. We give you one flat price per system agreed before work starts, with before-and-after photos of your own ducts. Call (844) 443-4566 for a free estimate.
Yes, we work with Honeywell controls and Aprilaire filtration and humidity components. We understand how sealed, correctly sized ducts affect what those systems can do, so the repair work and the air-quality setup work together. Whether you have Honeywell, Aprilaire, or another make, we can help. Call (844) 443-4566 to discuss your setup.
Same-day repair is often possible when the schedule allows, and we book it into the next opening if the day is full. We answer 24/7 on the phone. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. Call (844) 443-4566 to check the schedule for your Jackson Heights address.
We stand behind the work and cover our repair and sealing with a satisfaction guarantee, so if something we fixed doesn’t hold, we make it right. The written estimate spells out exactly what’s covered. If you’re unsure what your job includes, ask when you book. Call (844) 443-4566 for details.
Clear access to the furnace, air handler, and any visible duct runs, and move furniture away from vents and returns ahead of time. If you rent or manage the property, let whoever grants access know the visit window. We bring the equipment and handle the rest. If you’re in New York City and your building requires a permit for the work, most cities require one for larger duct changes, so ask your building’s management or the city’s building department ahead of time. Call (844) 443-4566 if you have questions before we arrive.
Schedule Your Duct Repair & Sealing Service in Jackson Heights Today
Leaky ducts cost you every month they stay open, and the fix is one call away. We bring professional equipment from Rotobrush and Nikro, clean and seal in the same visit, and leave you with photos of what changed. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Call (844) 443-4566 for a free, no-obligation estimate, and we’ll tell you exactly what your ducts need.
Written by the team at Air Duct Cleaning Jackson Heights.